SeaTrails 4000 is a programmable and configurable input
module (CCIM) that interfaces between various electronic sensors and
J1939 or NMEA Networks.
It is an ideal partner to the SeaTrails 3000.
Analogue to Can Converter Key Features
The ST4000 CCIM unit
measures the various sensor inputs, digitizes measurements, and then
sends the digitized data in packets to a remote display units such as
the SeaTrails 3000.
The ST4000 CCIM has 7
configurable analogue inputs that can be set to measure either voltage
or resistive signals.
There are 3 digital
inputs (for example a Tacho and two fuel inputs - sensors not
supplied).
It has a systems
voltage input for measuring battery voltage.
It also has a single
digital 1 Amp output driver - for use as say an external alarm or fuel
shut off feature.
Supports J1939 and NMEA
2000 CAN protocols plus NMEA Network Management
The ST4000 CCIM is
supplied fitted in a rugged automotive approved Deutsch enclosure /
connector system.
A CCIM PC config tool
is availiable to allow the customer to set up the module.
For more information about the SeaTrails 4000 fill out the request form on the right hand side of this page or contact us by clicking here.
